![wxtoimg reddit wxtoimg reddit](https://www.rtl-sdr.com/wp-content/uploads/2013/05/WXtoImgRecord.png)
Download the template and print it out, but make sure the printer doesn't scale it. I measured 1" as 35mm and 0.75" as 25mm (although I know 1 inch is 25mm when converted directly) using a tape measured that had cm on it, but your pipe may be different. Then just scroll down and insert the two PVC diameters in mm. Put the diameter of the conductor, which was 5mm for me. 15 I have the same issue with 1332, low volume on VB Cable output no matter what I do. Joined Messages 3,774 Location Berkeley Co WV. Then generate the template using this website. The default values for 137.5 MHz are good. Notice that the volume is at maximum and WXtoImg indicates only 38.6 volume. I already had copper pipe from a very old project to use for this antenna. I bought 1" and 0.75" PVC, but if I was going to do this again I would probably buy 1.5" and 0.5". I probably used this blog post the most, because it has links to a ton of other helpful posts. This is a pretty old ham radio project and now a lot of people are redoing it with the RTL-SDR, so there is a lot of information out there. This was in a small back yard on the west side, so I was getting good images from the west (next house is about 100 ft away westward). However, the program seems to want to record when the bird. Iteration 1: DiPole>RG1746ft>TV amplifier>RG620ft>RTLSDRV3>Rpi on a deck on a 5ft tripod.
#WXTOIMG REDDIT SOFTWARE#
Until recently, the software has been decoding as it should. I have a dedicated APT-06 receiver, Quad Helix antenna, and Wxtoimg software operating 24/7. (probably C:Program Files (x86)WXtoImgxwxtoimg. So extract RunAsDate and then configure it to have a date sometime in 2016 and choose WxtoImg to be run.
#WXTOIMG REDDIT INSTALL#
Recently I've seen a lot of people on the rtl-sdr reddit building quadrifilar helix (QFH) antennas to receive images from satellites using automatic picture transmission (APT). Im posting here as I do not believe there is a place for Wxtoimg software questions. Standard Edition Upgrade Key Install in Help -> Enter Upgrade Key (use upper/lower case exactly as below) Email Address: your email address Upgrade Key: ZC7W-KRKY-QLWT-4ZCT-AEB2. I've had one of these for months, and haven't really done anything cool with it. There is an incredibly popular low-cost software defined radio, known as the RTL-SDR.